Operation with other devices
Step
by
Step
For information on operation and call number assignment, please refer to
„Registering other devices" on page 18.
Registering a Gigaset 3000 Classic handset
z{~
on base station>, <INT No.>
Registering the Gigaset 2000S handset
Handset
number is assigned automatically by the base station).
Analogue terminal
The connection for a normal analogue terminal (such as a modem) must be set
up before this terminal can be put into service (see Setting the device type see
page 22).
Registering third-party GAP handsets
Press the green illuminated key on the base station.
1.
Prepare the GAP handset for registration (see the handset operating
2.
instructions). A connection is setup between the base station and the GAP
handset. The GAP handset is assigned the lowest available internal number. An
available internal number cannot be selected via the GAP handset.
Info
The display depends on the GAP handset used, as the base station does not
send display information to GAP handsets.
Activating and deactivating the repeater capability
The Gigaset repeater allows you to increase the range of your handset. Your
Gigaset 4070/4075isdn is set up to use a Gigaset repeater (as an accessory).
This function allows you to activate and deactivate the repeater capability.
Further information can be found in the operating instructions for the Gigaset
repeater.
Press
1.
Select using [
2.
settings
3.
Set using [OK]:
7RD.WLYDWHSUHVV
4.
ED.NSUHVV
60
<Base No.> [OK]<System Code>[OK] <Press green illuminated key
0
(off), press <Base No.> and
<press green illuminated key on base station> (smallest free internal
or *for selection menus.
] and [OK]:
o
Spec. function
'
before the menu command = ON / no = OFF
7KHKDQGVHWLVWKHQWHPSRUDULO\GLVDEOHG7RVZLW.K
[NEXT]
[BACK]
0
(on) simultaneously, System Code
Service Set up
or
Base Set up
o
Repeater
.
o
o
Settings
System