Table of Contents
Advertisement
Registering cordless Gigaset 1000TAE
Step
by
The cordless Gigaset 1000TAE allows analog terminals e.g. telephones, fax
Step
machines or answering machines to be operated cordlessly from your base
station.
The base station system PIN must be set to "0000" before the device is put
into operation, see Change system PIN see page 55.
1.
Press the green illuminated key on the base station.
Prepare the 1000TAE for registration (see the Gigaset 1000 TAE operating
2.
instructions).
A connection is setup between the base station and the TAE. The 1000TAE is
assigned the lowest available internal number. An available internal number
cannot be selected via the1000TAE.
Setting the device type for cordless TAE
When operating a cordless TAE on Gigaset 4070/4075isdn, you must define
the type of the connected device. Setting for:
O
Telephone = telephone
O
Fax = fax, see INFO below
O
Modem = modem
O
Answering mach. = answering machine (required for AM pickup)
O
Neutral = combined device
The default setting is "Telephone" .
Press
1.
Select using [
2.
o
user
This opens a list of internal numbers. Using [
3.
number of the registered cordless TAE.
Press [
3.
Using [
4.
command = selected.
Fax machines: To ensure that the fax machine can interpret the internal dial
Info
tone, it should be installed behind the PABX. Please refer to the operating
instructions for your fax machine.
If you encounter difficulties when connecting to other fax machines, e.g.
incorrect ID set at the ISDN remote station, then change the device type to
"Neutral" .
Combined fax machines: As these machines also include a telephony feature,
they must be set to "Neutral" and installed behind the PABX.
Registering the Gigaset M101 Data and M105 Data modules
(optional)
Gigaset M101 Data with its V24 interface and Gigaset M105 Data with its USB
interface enable cordless PC connection to the base station, e.g. for Internet
access.
O
For setting up see the chapter entitled "Operating Gigaset talk&surf with a
cordless data module" in the installation instructions.
or *for selection menus.
] and [OK]:
Service Set up
Set up device
.
9
] and select using [
] and [OK] select the desired device type,
or
Base Set up
] and [OK] select the internal
] and [OK]:
Device select.
o
o
Settings
Set up
'
in front of the menu
61
Advertisement
Table of Contents
