Beta Marine Beta 43 Operator's Maintenance Manual page 62

The graphs below illustrate charging voltage for different battery types
Volt
16
15
14
13
12
-20 0 20 40
Maintenance-free Batteries and deep-cycle Batteries
Volt
16
15
14
13
12
-20 0 20 40
Conventional Batteries
Volt
16
15
14
13
12
-20 0 20 40
THIS CONTROLLER SHOULD NOT BE MOUNTED ON THE ENGINE!
DIP-switch
positions
U1
U2
C
1 - OFF
2 - OFF
60
DIP-switch
positions
U1
U2
C
1 - ON
2 - OFF
60
DIP-switch
positions
U1
U2
C
1 - OFF
60 2 - ON
Gell Batteries
DIP-switch
Remove cover for setting of DIP switches:
Cover removal for resetting of DIP switches
U1 = Mode B (Orange lamp)
U2 = Mode C (Green lamp)
U1 = Mode B (Orange lamp)
Note: Before removing any covers ensure that all
batteries and the controller are disconnected.
U2 = Mode C (Green lamp)
The two DIP switches inside the controller must be set
according to battery type. As standard the Beta
Note: ensure all batteries are switched off, controller is
Controller is supplied to suit lead acid batteries. If you
disconnected from wiring before removing any covers.
are in doubt of your battery type, check with battery
Voltage setting for battery charge is done through the
supplier before fitting the controller.
two DIP switches inside the controller. Remove the
The cover is removed by undoing the top four screws
cover by removing the top four screws and loosening
the bottom four. This cover is sealed on to prevent
and loosening the bottom four. This cover is sealed on
water ingress, this seal must be broken for cover
to prevent water ingress, this seal will be broken when
removal.
the cover is removed.
Set the dip switches to the required settings as
illustrated on the charts opposite.
Set the dip switches to suit your battery – the settings
Re-seal controller with silicon sealant or equivalent
are detailed on the charts opposite.
after setting switches.
Re-seal controller with silicon sealant or equivalent after
As standard the controllers are supplied to Beta Marine
setting switches.
to suit lead acid batteries.
Beta Marine is not responsible for the incorrect setting
If in doubt on battery type check with battery supplier
of dip-switches as we do not know which batteries you
before fitting controller.
have.
responsible for incorrect switch setting for each
installation.
All goods are offered and supplied in accordance with
our 'General Terms of Tender Sale'.
60
LED
Beta Marine are not