Troubleshooting - Panasonic ECONAVI NA-FS95G3WAU Operating Instructions Manual

Troubleshooting

Before requesting service, make the following checks. If the problem still persists, consult your dealer for
instructions.
Problem
The washing machine
does not turn on.
Buttons do not work.
There is an unusual
noise or vibration.
Water is not supplied.
Water pressure is low.
Water level is too high
for the amount of
laundry being washed.
Water level is too low
for the amount of
laundry being washed.
Water starts filling the
tub in the middle of the
wash cycle.
When I start the rinse
cycle, water does not fill
the tub.
A rinse starts suddenly
during the spin cycle.
24
Check points
●
Is there a power failure?
●
Did you press the [Power On] button?
●
Is the power plug connected securely?
●
Is the power fuse broken or the breaker turned off?
●
You cannot operate the [Temp Setting] button once a cycle
starts.
You can operate the [Water Level] button until the end of the
wash stage of a cycle.
You can operate the [Wash], [Rinse] and [Spin] buttons after
pressing the [Pause] button until the end of the wash stage of a
cycle.
To change the other settings, turn off and on the washing
machine.
●
Do not place the washing machine on an uneven or unstable
surface.
●
Are the clothes out of balance?
→ Press the [Pause] button, redistribute the clothes, and restart
the cycle.
●
Are the water taps turned on?
●
Is the water supply cut off?
●
Is the water pipe or are the water supply hoses frozen?
●
Are the water supply filters clogged?
→ Clean the water supply filters.
●
If you load clothes drenched in water or if the tub was filled
with some water before the cycle started, the water level may
become high.
→ Press the [Water Level] button repeatedly to change the
water level.
●
Light clothes made of synthetic or blended fabric may lower the
water level.
→ Press the [Water Level] button repeatedly to change the
water level.
●
When the water level goes down, the tub will be filled
automatically.
●
The tub may be filled automatically when the amount of laundry
is large.
●
If the tub is empty, it will be filled after the spin cycle.
●
If the tub is filled, it will be drained first.
●
If the clothes are out of balance, the washing machine starts a
rinse automatically to rebalance them.
→ Try to load the clothes evenly.
Page
–
–
–
–
11
6
–
–
–
25
23
11
11
–
–
–
–
–