Panasonic ECONAVI NA-FS95G3WAU Operating Instructions Manual page 7

3
Install the water drain hose.
Detach the water drain hose from the hose
holder on the back of the washing machine, and
place it in a tub, sink, wash-basin, standpipe, etc.
●
When draining to a tub,
sink or wash-basin:
Hose
guide
Water
drain hose
●
Fit the hose guide to the water drain hose to
guide the water drain hose over the tub, sink,
wash-basin, standpipe, etc.
●
Install the water drain hose as below to prevent
siphoning.
– Do not extend the
water drain hose
more than 20 mm
beyond the end of
the hose guide.
– Install the end of
the water drain
hose at a height
of 0.7 m to 1.1 m.
– Install so that the end of the water drain hose
will not be soaked in water.
– To prevent siphoning, do not fit directly to a
drain spigot unless an air gap is present.
If it is impossible to install the water drain hose
as instructed above, adjust its length by trimming
it to length or by extending it with an extension
drain hose. Limit the total length of the extended
hose to 2 m or less.
●
Regularly check that the tub, standpipe, etc.
is free from lint or other obstructions. (Not
doing so may affect how the washing
machine works or may cause flooding.)
●
Draining must comply with local by-laws.

●
When draining to a
standpipe:
Stand
pipe
Water
drain
hose
Hose
guide
Max.
20 mm

Max. 1.1 m
Min. 0.7 m
●
4
Connect the water supply hoses
to the washing machine.
Press the end of the supplied water supply
hose (grey) with an elbow straight against the
water supply valve screw on the back of the
washing machine indicated as "COLD", and
tighten the nut clockwise with your hand.
Water supply
valve screw
Water supply
hose (COLD)
Water supply
hose (HOT)
Likewise, connect the supplied water
supply hose (white) to the water supply
valve screw on the back of the washing
machine indicated as "HOT".
Check whether or not the elbows are
unsteady or loose.
Nut Nut
Elbow
7