Table of Contents
Advertisement
A. Introduction
This section provides system programming using
VT compatible terminals. Before starting system
programming, Section 7 "Preparation for
Programming and Maintenance (VT220 and
Compatibles)" must be read. This section
provides the basic operations required for system
programming.
Programming consists of 10 submenu screens
and each submenu consists of
screens.
The setting screens are
various parameters concerning the system
administration such as Tenant, Class of Service,
Numbering Plan and so on.
The setting screens should be programmed in
order of "First Set," "Second Ser and "Third Set"
which is illustrated in "Construction of
Programming Mode" on the following page. If
you program a screen in the second set before
setting the first-set screens, an error message
will appear. For example, if you program
"Extension" before programming
DN Assignment," an error message is displayed.
In this section, each setting screen is explained
using a screen and an explanation table.
various setting
to assign or change
used
9-A-l
Advertisement
Chapters
Table of Contents
