Table of Contents
Advertisement
(4) SLT On-hook Operation Mode
In single line telephone procedures, active call is put on consultation hold
when the switchhook is pressed down for approximately
released.
In this case, consultation hold recall tone will ring immediately if you replace
the handset on the switchhook without dialing any digits.
Then you may hear recorder tone when you lift the handset to reply this
ringing
This, may happen sometimes if the handset is replaced on the switchhook
after hopping on it.
To prevent such unexpected consultation hold tone from ringing, select
for this setting.
When setting "Y is selected,
a call put consultation hold will be disconnected if you replace the handset
on the switchhook without dialing any digits.
When '1 I is selected. - default
Talking
(1)
Talking with a
caller.
When "Y is selected
(1) Talking
Talking with a
caller.
(Note)
To hang up and make another call right away, an SLT user should
hold down the switchhook for more than two seconds.
(Parameters)
1 : Hang-up causes ringing of consultation hold recall tone. (default)
2 : Hang-up disconnects a call on consultation hold.
(3) On-hook
(2) Hooking
A call is put on
consultation
hold.
(3) On-hook
(2) Hooking
consultation
hold.
10-C-82
(30393)
. .
Recall
(4)
Consultation hold
tone rings.
any digits.
(4) Disconnection
Without dialing
A call on
consultation hold
any digits.
is
be sure to
Advertisement
Chapters
Table of Contents
