Fixed Error Messages - Panasonic KX-T336200 Installation Instructions Manual

3.00 Fixed Error Messages

DATA ERROR No.
Unacceptable value is assigned.
003
Space exists between items.
004
Some items are left blank.
005
At least one blank should be left among multiple Leave at least one blank.
006
items.
Assigned selection value is not for the item,
007
The number which is set previously in this
008
screen is assigned again.
The number which is set previously in a different Set the number different from the previous
009
screen is assigned.
Device is not installed.
012
Status of the specified device does not accept
013
this command.
Privilege level is lower than specified level.
016
Diagnostic error has been detected when INS
0 1 7
command is executed.
Specified service is not executed.
018
Another maintenance device (remote, PITS,
019
system) is in use.
Printer is not connected to the system or the
020
power is off.
Print out is unavailable from Remote.
021
Entered parameters for Item or Index ia out of
022
the spepified range.
023
programming.
Calendar IC malfunction.
024
Backup device is not connec$ed (only when
027
maintenance device is ATT).
Diierent version at the time of backup.
029
Probable Cause
l
, &I+ " is entered in BT (Batch)
10-D-6
(21292)
Countermeasure
Assign an allowable value.
Remove the space.
Assign all required items, or leave all items
blank.
Set the assignable value.
Set the number different from the previous
number.
number.
Assign the installed device.
Change the.status of the device to be
acceptable for the command.
Increase the privilege level through the
Change level function.
Verify the related device.
Check specified service.
Wait until another device is finished or let him
finish.
Connect the printer, and make the power on.
Execute print out on-site.
Enter the parameters within the specified
range.
Correct the wrong entry.
Repair calender IC.
Connect the backup device to SIO # 1 Port.
Match the backup version.