Table of Contents
Advertisement
D. Error Message Tables
1.00 Error Messages Related to
the Assigning Items in the
Same Command
If there is a wrong entry in the displayed screen,
the following appears on the message line when
storing the entry: "DATA ERROR (XXX)."
ERROR No.
DATA
(page length)-(skip length) < 6
(receive digit) 2 (delete digit) is not established
101
in - Special Attended DID screen.
Restriction Level-Operator s Restriction Level-
102
International is not established in - Operation
Day-night combination in the incoming mode is
110
not correct.
Combination of the terminals of operators I,2
130
is incorrect.
DN is not installed.
140
.
Attempting to assign FDN's of UCD # 1 to # 4
141
for the overflow destination of UCD # 5 to # 32
Attempting to assign its own extension number
'150
on the key which cannot be assigned to its own
extension number.
Specifying UCD number incorrectly.
160
Date value is incorrect on the check of month,
190
and leap year in the time and date setting
Probable Cause
screen
SDN
The (XXX) indicates one of the error message
numbers shown below and possible causes of the
errors and countermeasures for them are as
follows.
Make (page length)-(skip length) Z 6.
Make (receive digit) 2 (delete digit).
Make Restriction Level-Operation 6
Restriction Level-International
Change the day-night combination in
incoming mode.
Change the combination of terminals for
operators 1.2.
Designate the installed DN.
Set FDN of other UCD. or extension director]
number.
Specify the number except its own extension
number.
Assign UCD to only one ICM.
Check the date setting.
lo-D-1
Countermeasure
Advertisement
Chapters
Table of Contents
