Panasonic KX-T336200 Installation Instructions Manual page 52

7.04 Paging Group
Description
It is possible to execute paging functions in a
group composed of one or more pickup groups.
Such a group is called
a
Up to eight paging groups can be assigned in the
system.
When Tenant Service is employed, the 'Group-
Group" screen sets which tenant the
paging group belongs to.
The "Group-Call Pickup Group" screen sets
which pickup group(s) make up a paging group.
Programming
Paging GroupTenant
'Group-Call Pickup Group",
P A G
Conditions
If tenant service is employed, pickup groups
which can be used to configure a paging group
are limited within the same tenant.
See Section 4-H-l .OO "Paging" for further
information about paging features.
"Paging Group."
Reference
VT 1 Dumb
9-E-2.00 10-C-16.00
9-E-3.00
10-G17.00
3-B-l 3
(70695)
7.05 Trunk Group
Description
efficient utilization of trunks, they can
To support
be grouped together (up to 16 groups) if all
trunks in the group perform the same function.
The following six kinds of trunk groups can be
assigned in the system.
The items listed below are set in the "Group-
Trunk Group" screen.
Trunk group type
Trunk group name
Tenant selection
Trunk group direction
Incoming destination (Day)
Incoming destination (Night)
Intercept Routing (Day)
Intercept Routing (Night)
Toll restriction level
Toll restriction table
Dialing plan selection
Disconnect time selection
(m) Pause time selection
(n) Hookswitch flash time selection
(p) Entry of PBX access code (No restriction)
( q ) Entry of PBX access code (Restriction)
(r) Restriction time on CO-CO calls
(s) DIL (I:N) destination
(t) Maximum number of digits after External
Feature Access
(u) CO-TIE Restriction
(v) TIE-CO Restriction
(w) TIE Forced Account Mode
(x) TIE Incoming Delete Digit
(y) TIE Incoming Insert Dial
The "Trunk-CO Line", Trunk Group determines
which trunk group the CO line belongs to.
Programming
Conditions
single CO line cannot belong to more than one
A
trunk group.