Calling From Tie To Co - Panasonic KX-T336200 Installation Instructions Manual

14.02 Calling from TIE
Description
I
I
I
I
I
I
Programming example:
PBX-1
to CO
TIE Lines can be used to minimize the cost of calls to a distant location outside
of the TIE Line Network. A long distance call from one location may be a local
call from another location. This fact must be taken into consideration before
making a long distance call.
If the destination of the long distance call is outside of the TIE Line Network,
extension users first call to a distant PBX via TIE Line and then can
local CO call to the final destination through that PBX.
A Network of TIE Lines
PBX-1
Ext. 100 Inside of the TIE Line Network
Call Flow
1. Ext.100 dials 64-951-g (TIE Trunk Access Code + PBX Code + CO Access
Code).
2. Ext.1 00 is required to enter a TIE account code*.
3. Ext.100 hears dial tone from an idle CO line of PBX-2.
4. Ext.100 dials xxx-xxxx (phone number of the outside party).
*Step 2 is required when "TIE Forced Account Code" Mode is set to "Yes" at
PBX-2:
To make up the TIE Line Network above, the following system programming is
required at PBX-1 and -2 respectively.
System - Operation (l/3) (9-D-l .Ol , 1 O-C-4.00)
l
PBX Code: 950
Special Attended - TIE Line Routing Table (9-K-4.00, 10-C-65.01)
l
No.
C o d e Delete
Digit
0 1 9 5 1 0
02
.
3-F-76
(70695)
I
Insert Trunk Group Hunt Sequence
Dial 0 1 0 2
1 0
.a
make