Computer And Video Server Connections - Sanyo VSP-SV2000 Instruction Manual

Network Video Server Settings

2 Computer and Video Server Connections

Once the plug-in software has been installed, use the computer's web browser to access the video
server.
Note: The network video server handles large volumes of image data that has been compressed into
JPEG2000 format. In order to provide smooth access to the video server, you should close any
other applications that you do not need to have open.
1
Click on the Network icon in the
computer's Control panel, and then set
the computer's IP address and subnet
mask.
•
IP address: Type in "192.168.0.*". The
video server's IP address is set to
"192.168.0.2", so set "*" to "3" or greater.
•
Subnet mask: Type in "255.255.255.0".
2
Use an Ethernet cable to connect the
ETHERNET connector of the video server
to the computer.
To make an external connection between the
video server and the computer, refer to
"Basic connections" in the "Connections"
section. (p. 7)
3
Turn on the power for the video server.
4
Start the web browser on the computer.
5
Type http://192.168.0.2 into the location
bar of the web browser, and then press
the [Enter] key.
The password entry window will be displayed.
6
Type in "ID3" as the Username and
"3333" as the password, and then click
the [OK] button.
The language selection window will be
displayed.
Note:
•
In order to carry out the various settings listed
here, you need to enter the password "3333"
that has been set for administrator level access
at the time of shipment from the factory.
Different passwords can be set for up to three
access levels. Refer to "NETWORK SET
Settings" for details on setting the passwords.
(p. 17)
•
If you type in an incorrect password or click the
[Cancel] button, a pop-up window will be
displayed. If you do this three times in
succession, "AUTHENTICATION ERROR,
PLEASE ENTER YOUR ID AND
PASSWORD!" will be displayed.
Language selection window
– 14 –
English