Table of Contents
Advertisement
SSP Settings (RS-485)
Connection Examples for Equipment with SSP
(Dome Camera)
Turn off the power supply for all equipment, and
then use twisted pair cables to connect the
devices that are equipped with an RS-485
control connector to the video server.
1
Make the following connections.
Camera A: Connect a normal CCD camera
to VIDEO IN 1 and 2.
Camera B: Connect a dome camera with
SSP function to VIDEO IN 3 and 4.
2
Click the [SINGLE VIEW] menu select
button.
The control panel for equipment with SSP
function will be displayed.
3
Change the CATEGORY setting to "CAM".
While looking at the images from camera B
that are being transmitted via the network,
click the CAM buttons to pan and tilt the
dome camera.
Note:
Camera A is for monitoring images only; it
cannot be operated using the CAM buttons.
ALARM
ALARM
1 2
3
4
COM
IN
OUT
GND
IN
OUT
12VDC
VIDEO 1
Camera A
PC
MODEM
ON
1 2
TERMI
RS-232C
COM
A
B A B
RS485
IN
OUT
IN
OUT
VIDEO 2
VIDEO 3
Camera B
Note:
•
The twisted pair cables should always have signal A
connected to signal A, and signal B connected to
signal B, and the ground should always be
connected too.
•
If more than one device is connected, enable the
termination settings for the devices at both ends of
the series. Set communication/terminal select
switch 1 at the rear of the video server to the "ON"
position, and set the termination switch for the last
device in the series to "ON". All other devices
should have the termination settings set to "OFF".
3
– 46 –
Computer
Monitor TV
ETHERNET
ALL RESET
IN
OUT
VIDEO 4
ID3
English
Advertisement
Table of Contents
