Table of Contents
Advertisement
2.8
Cable connections
•
The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
•
Refer to Chapter 4 for detailed information on the connectors.
2.8.1
Motherboard connections
KBMS1
3
PSUSMB
USB12_L3
DDR DIMM_B1 (64bit, 240-pin module)
DDR DIMM_A1 (64bit, 240-pin module)
DDR DIMM_B2 (64bit, 240-pin module)
DDR DIMM_A2 (64bit, 240-pin module)
DDR DIMM_B3 (64bit, 240-pin module)
DDR DIMM_A3 (64bit, 240-pin module)
4
REAR_FAN2
LAN1
LAN2
BCM5721
LAN_SW1
BCM5721
REAR_FAN1
LAN_SW2
Z9s
VGA_SW1
RECOVERY1
AMI
IDE_SW1
SB_PWR1
8Mb
CHAFAN_SEL1
BUZZER1
Super
I/O
PIKE1
Standard cables connected to the motherboard
1.
24-pin ATX power connector (from power supply to motherboard)
2.
8-pin 12V power connector (from power supply to motherboard)
3.
Power supply SMBus connector (from power supply to motherboard)
4.
System fan connectors (from system fan to motherboard)
5.
USB connector (from motherboard to front I/O board)
6.
IDE connector (from motherboard to the optional drive)
7.
Chassis Intrusion connector (from rear chassis intrusion switch to motherboard)
8.
Serial General Purpose Input/Output connectors
(SATA: from motherboard SGPIO1 to SATA/SAS backplane J2 connector
SAS: from motherboard SGPIO2 to SATA/SAS backplane J6 connector
SAS: from motherboard SGPIO3 to SATA/SAS backplane J7 connector)
9.
System panel connector (from motherboard to front I/O board)
10.
SAS connectors (for ASUS PIKE only; from motherboard to SATA/SAS backplane)
ASUS TS500-E5
24.5cm (9.6in)
1
2
EATXPWR1
CPU_FAN1
Intel
5100P MCH
COM2
PCIE2
ASMB3
PCIE3
PCI4
Lithium Cell
CMOS Power
IT8213F
PRI_IDE
AUX_PANEL1
PCIE6
7
PIKE2
EATX12V1
CPU1
CPUFAN_SEL1
CPU2
CPU_FAN2
RAID_SEL1
USB56
CLRTC1
6
Intel
82801IR
(ICH9R)
FRNT_FAN1
HDLED
10
IBTN_SEL1
CPU_WARN1
5
FRNT_FAN2
FRNT_FAN3
FRNT_FAN4
USB34
8
SGPIO3
SGPIO2
SGPIO1
9
PANEL1
2-23
Advertisement
Table of Contents
