Table of Contents
Advertisement
5.6.3
APM Configuration
Restore on AC Power Loss
Power On By External Modems
Power On by PME
Power On By RTC Alarm
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into off state after an AC power loss.
When set to [Power On], the system will reboot after an AC power loss. When set
to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By External Modems [Disabled]
This allows either settings of [Enabled] or [Disabled] for powering up the computer
when the external modem receives a call while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Setting this item to [Enabled] allows the computer to power up even when the
Serial Port1/2 Address item in the Onboard Device Configuration menu is
set to [Disabled]. See section 5.4.4 Onboard Device Configuration for details.
Resume On PME [Disabled]
When set to [Enabled], the system enables the PME to generate a wake event
while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake-up event.
Configuration options: [Disabled] [Enabled]
5-26
[Last State]
[Disabled]
[Disabled]
[Disabled]
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
BIOS SETUP UTILITY
Power
<Enter> to select
whether or not to
restart the system
after AC power loss
Select Screen
←→
Select Item
↑↓
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 5: BIOS setup
Advertisement
Table of Contents
