Table of Contents
Advertisement
8.
Intel
ICH9R SATA port S/W RAID setting (3-pin RAID_SEL1)
®
This jumper allows you to select the Serial ATA RAID configuration utility to
use when you create disk arrays. Both utilities are supported by the
Intel
®
ICH9R. Place the jumper caps on pins 1–2 if you want to use the LSI
Software RAID Configuration Utility (default); otherwise, place the jumper
caps on pins 2–3 to use the Intel
DSAN-DX/TS500-E5 RAID setting
9.
iBTN RAID setting (3-pin IBTN_SEL1)
This jumper allows you to select the RAID configuration utility to use when
you create disk arrays. Place the jumper caps on pins 1–2 if you install a
PIKE RAID card to the motherboard and want to use the LSI Logic MPT
Setup Utility (default). Or you can place the jumper caps on pins 2–3 to create
the LSI Mega RAID 5 by supported Intel
DSAN-DX/TS500-E5 IBTN setting
•
•
4-8
LSI Logic MPT Setup Utility is available only when you install a PIKE RAID
card.
LSI Mega RAID 5 fucntion is available only when you place the iBTN to
I_BTN1 socket.
Matrix Storage Manager (IMSM).
®
RAID_SEL1
1
2
2 3
Intel
3rd
(Default)
®
ICH9R SATA controller.
IBTN_SEL1
1
2
2 3
ICH9R RAID5
PIKE RAID5
(Default)
Chapter 4: Motherboard information
Advertisement
Table of Contents
