Toshiba E-STUDIO190F Service Manual page 148

5.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode and press "6" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press "V", "/\" arrow keys.
↓
If you wish to select another code number, scroll the menu with the arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press "SET" key.
↓
When the "CLEAR" key is pressed, the selected code input will not be accepted.
↓
Press "STOP" key, then press "FUNCTION" and "CLEAR" keys sequentially to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Note:
1. The Factory Setting is different for each model.
2. To change the input value +/-, press "<", ">" cursor keys.
3. The machine may accept a (+/-) input value that exceeds the specified Setting Range for the
parameters in the table; however, the actual registered value will not exceed the Upper/Lower
Limitation value.
No.
00-03 Not Used
04 Printer Registration
05-06 Not Used
07 Registration Void
08 Not Used
09 Trail Edge PRT Tim.
10 Side Adjust (Bypass)
11 Side Adjust (Tray 1)
12 Side Adjust (Tray 2)
13-15 Not Used
16 Side Adjust (ADU)
17-38 Not Used
39 LSU Unit PWM Adjust
40 Trans Current Side 1
Item
Delay time is adjusted from registration roller
clutch ON.
Registration void should be adjusted.
Adjustment of trail edge void.
Adjustment of LSU side-side (Sheet Bypass).
Adjustment of LSU side-side (1st Tray).
Adjustment of LSU side-side (2nd Tray).
Adjustment of LSU side-side (ADU).
Adjustment of PWM value of LSU.
Adjustment of Transfer Current.
F6 Mode
Remarks
148
Setting
Range
-50 - +16
0.5mm
0 - +99
0.5mm
-9 - +15
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-32 - +32
-77 - +76
0.15uA