Toshiba E-STUDIO190F Service Manual page 242

(11) Remove the Black Pin Protector from Slot 1
(CN515), if it was preinstalled.
(12) Install 2 PC Board Supporters for the Slot 1 on
the SC PC Board.
(13) Install the Program Expansion Board into Slot
1 (CN515) on the SC PC Board and secure with
the Supporters.
Note:
The Program Extension F-ROM Board must
always be installed into Slot 1 (CN515) for the PCL
Printer Option to function.
(14) Proceed with the installation of other options.
If finished, reinstall the SD Memory Card if it was
removed, and all Harnesses and Covers.
(15) Plug the AC Power Cord and turn the Power
Switch on the Rear Side of the machine to the
ON position.
(16) Reconnect the Telephone Line Cable if it was
disconnected.
(17) Update the firmware of the unit to the PCL
Option firmware. Refer to section 8.1 Service
Notes of this manual.
(18) Install the PCL6 Software into the PC with the
Operator's Manual by following the prompts of
the Installation Wizard.
242