Toshiba E-STUDIO190F Service Manual page 152

5.1.8. F9 Mode: Unit Maintenance
Set the machine to Service Mode and press "9" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press "V", "/\" arrow keys.
↓
If you wish to select another code number, scroll the menu with the arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press "SET" key.
↓
When the "CLEAR" key is pressed, the selected code input will not be accepted.
↓
Press "STOP" key, then press "FUNCTION" and "CLEAR" keys sequentially to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Service
Mode
F9 Unit
Maintenance
Item
00 Fax Function Parameter
01 Service Alert Tel #
02 Firmware 00 SC
Version
01 SC Boot
02 PNL
03 Scanner
04 Printer
05 FAX Modem
06 G3B Board
07 SC2
03 Print 00 F5/F6 Parameters
Device Info.
01 Machine Information Prints the machine setup information list.
02 Counter Information Prints the Counter information list.
03 System Address
Info.
04 RAM Address
Information
04 RAM Edit 1 Relative Address
Mode
2 Absolute Address
05 Serial Number
F9 Mode
Displays the contact number when a
machine malfunction occurs.
Displays the firmware version for SC.
Displays the firmware version for SC
Boot.
Displays the firmware version for PNL.
Displays the firmware version for SDR.
Displays the firmware version for
finisher.
Displays the firmware version for FAX.
Displays the firmware version for G3B.
Displays the firmware version for Slot 1.
Prints the memory contents of the F5
and F6 modes.
Prints the system memory setting.
Prints the RAM data dump list.
Setting of Relative address.
Setting of Real address.
Registration of Serial Number for
Maintenance.
Clears with Shipment Set.
152
Remarks