Activate The Alarm - Silvercrest SWED 500 A1 User Manual And Service Information

radio that is being used as an alarm. The volume of the buzzer alarm is
unaffected by this setting.
The alarm time has now been set.

Activate the alarm

Below is a description of how to set up AL1. The same procedure applies to
AL2.
When you have set the alarm time, you can activate the alarm function as
follows:
 When the radio is switched off, briefly press the 'VOL-/AL1' button (2)
once to activate the radio alarm. The associated icon (31) appears on the
screen.
Please note that earphones must not be connected when using the
radio alarm.
 Briefly press the 'VOL-/AL1' button (2) for a second time to activate the
buzzer alarm. The associated icon (30) appears on the screen.
 At the time the alarm was set for, the device will switch on automatically, at
the same frequency that it was last tuned to and in the same frequency band.
However, if you chose the buzzer alarm setting, you will be woken up by this
instead.
 To switch off the alarm sound, press the 'VOL-/AL1' button (2) or press the
'SNOOZE' button (4) to delay the alarm for about five more minutes. The
alarm icon (30, 31) will be flashing. Once the five minute snooze period if
over, the alarm sound will switch on again. If you press the 'BAND' button
(9) during the five minute snooze period, the snooze function will be
deactivated but the alarm function will remain activated.
The default setting for snooze duration is five minutes. You can
increase the snooze time up to 120 minutes, according to your
SilverCrest SWED 500 A1
English - 33