Pc Programming - Panasonic KX-TDA600 Feature Manual

2.7.4 First Party Call Control CTI Connection
KX-TDA600
2.9.4 First Party Call Control CTI Connection
Programming References
PC Programming Manual
2.8.5 [1-1] Slot—Port Property - Extension Port
→ DPT Type—Type
→ DPT Type—Location No.
PT Programming Manual
[601] Terminal Device Assignment
Feature Manual References
2.1 Capacity of System Resources

1.13.6 PC Programming

Description
Although many PBX features can be programmed using a proprietary telephone (PT) (→ 1.13.28 PT
Programming), a PC connected to the PBX can use the Maintenance Console software to program in further
detail. System programming, diagnosis, and data upload/download can be performed either through on-site
programming or remote programming.
1)
On-site Programming: Programming that is performed using an on-site PC connected directly to
the PBX.
2)
Remote Programming: Programming that is performed using an off-site PC that connects to the
PBX via a CO line.
1.
Connection Methods for On-site Programming
Method
Serial Interface
(RS-232C port)
USB
LAN
Modem
(connected to SLT
port)*
Description
The PC is connected to the PBX via the Serial Interface
(RS-232C port) of the PBX.
The PC is connected to the PBX via the USB port located
on the MPR card, or to the USB port of a USB Module
attached to a digital proprietary telephone (DPT).
The PC is connected to the PBX via Ethernet cable to the
CTI-LINK card (KX-TDA100/KX-TDA200/KX-TDA600 only)
or IP-GW4 card (KX-TDA50 only).
The PC is connected to a modem, which is then connected
to an SLT port of the PBX. Use the modem to dial the
floating extension number (default: 599) assigned to the
analog remote maintenance feature to access the PBX.
1.13 P
Required
Hardware
—
MPR card
(preinstalled) or
USB Module
CTI-LINK card or
IP-GW4 card
RMT card and
user-supplied
modem
Feature Manual 199