Rear Axle Assembly - Toro Groundsmaster 4000-D Service Manual

Rear Axle Assembly

RIGHT
FRONT
135 to 165 ft- -lb
(184 to 223 N- -m)
1. Plug with O- -ring
2. Lug nut (5 used per wheel)
3. Rear wheel assembly (2 used)
4. Cap screw (2 used)
5. Flat washer (8 used)
6. Rear axle motor
7. O- -ring
8. Steering cylinder
9. Spacer
10. Cotter pin (2 used)
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Axles, Planetaries and Brakes
18
5
16
15
17
27
24
20
25
27
26
21
Figure 12
11. Slotted hex nut (2 used)
12. Washer
13. Cap screw (4 used)
14. Lock washer (4 used)
15. Bulkhead mount plate
16. Grommet (2 used)
17. Bulkhead nut (2 used)
18. Cap screw (6 used)
19. Frame assembly
20. Lock nut (6 used)
Page 6 - - 18
19
8
22
28
12
29
14
9
10
23
11
13
85 to 100 ft- -lb
(115 to 135 N- -m)
21. Rear axle mount
22. Rear axle assembly
23. Lock nut
24. Thrust washer
25. Rear axle pin
26. Washer head screw
27. Grease fitting
28. Thrust washer (0.033")
29. Thrust washer (0.018")
Groundsmaster 4000--D/4010--D
6
7
1
1
4
5
3
2