Windshield Wiper/Washer Switch - Toro Groundsmaster 4000-D Service Manual

Windshield Wiper/Washer Switch (Groundsmaster 4010- -D)
The windshield wiper/washer switch is used to control
operation of the windshield wiper and washer pump on
the Groundsmaster 4010--D. The windshield wiper/wa-
sher switch is located in the cab headliner (Fig. 46).
Testing
1. Make sure ignition switch is OFF. Remove key from
ignition switch.
2. Remove switch plate from cab headliner.
3. Locate windshield wiper/washer switch and unplug
wire harness connector from switch.
4. The switch terminals are marked as shown in Figure
47. The circuit logic of the wiper/washer switch is shown
in the chart below. With the use of a multimeter (ohms
setting), the switch functions may be tested to determine
whether continuity exists between the various terminals
for each position. Verify continuity between switch termi-
nals. Replace wiper/washer switch if testing identifies a
faulty switch.
SWITCH CLOSED
POSITION CIRCUITS
OFF 2 + 1
WIPER ON 2 + 3
WASHER and 2 + 3
WIPER ON 5 + 6
(MOMENTARY)
5. If switch tests correctly and circuit problem still ex-
ists, check wire harness (see Electrical Schematics and
Wire Harness Drawings in Chapter 10 -- Foldout Draw-
ings).
6. Connect the wire harness connector to the switch af-
ter testing.
7. Install switch plate to cab headliner after switch test-
ing is complete.
Groundsmaster 4000--D/4010--D
1. Cab headliner
OPEN
CIRCUITS
5 + 6
5 + 6
2 + 1
Page 5 - - 41
2
Figure 46
2. Wiper/washer switch
BACK OF SWITCH
Figure 47
Electrical System
1