Windshield Washer/Wiper Switch - Toro Groundsmaster 360 Service Manual

Windshield Washer/Wiper Switch (4WD Machines with Operator Cab)
The windshield washer/wiper switch is used to control
the windshield washer and wiper. When the front of the
switch is depressed, both the wiper and the washer will
be off. When the switch is in the center position, the wip-
er will be on. Both the washer and wiper will be on when
the rear of the switch is depressed and held. The wash-
er/wiper switch is located on the cab control panel (Fig.
44).
Testing
1. Park machine on a level surface, lower cutting deck,
engage parking brake and stop engine.
2. Make sure ignition switch is in the OFF position. Re-
move control panel from cab headliner to gain access to

windshield washer/wiper switch.

3. Disconnect machine wire harness electrical connec-
tor from the windshield washer/wiper switch.
4. The windshield washer/wiper switch terminals are
identified in Figure 45 and the switch circuits are shown
in Figure 46. With the use of a multimeter (ohms setting),
the switch functions may be tested to determine whether
continuity exists between the various terminals for each
switch position. Verify continuity between switch termi-
nals.
5. Replace windshield washer/wiper switch if testing
determines that it is faulty.
6. If the windshield washer/wiper switch tests correctly
and a circuit problem still exists, check wire harness
(see Electrical Schematics and Wire Harness Drawings
in Chapter 9 -- Foldout Drawings).
7. After testing is complete, connect machine wire har-
ness connector to windshield washer/wiper switch. Se-
cure control panel to cab headliner with removed
fasteners.
Groundsmaster 360
1. Cab control panel
SWITCH
POSITION
OFF
WIPER ON
WASHER ON
Page 5 - - 35
2
Figure 44
2. Washer/wiper switch
BACK OF SWITCH
Figure 45
NORMAL OTHER
CIRCUITS CIRCUITS
2 + 1
2 + 3
2 + 3 5 + 6
Figure 46
Electrical System
1