Toro Groundsmaster 360 Service Manual page 118

28.Remove two (2) hex plugs and one (1) socket head
plug from gear case housing. Remove and discard O--
rings from plugs.
29.Remove fifteen (15) flange head screws that secure
gear case housing to transmission pump housing.
30.Carefully remove gear case housing from pump
housing.
31.Locate and retrieve two (2) pins from gear case
housing holes. Remove and discard gasket.
32.Remove retaining ring that secures input shaft oil
seal into gear case housing bore. Remove spacer and
oil seal from housing taking care to not damage seal
bore in housing. Discard seal.
Hydraulic System
2
1. Hex plug
1
3
2
1. Gear case housing
2. Pump housing
Page 4 - - 84
1
Figure 78
2. Socket head plug
Figure 79
3. Pin (2 used)
Groundsmaster 360
1