Toro Groundsmaster 360 Service Manual page 266

4. If rear steering fork assembly was removed, install
fork assembly (see Rear Steering Fork Installation in
this section).
5. If rear wheel motor was removed, install wheel motor
(see Wheel Motor Installation in the Service and Repairs
section of Chapter 4 -- Hydraulic System).
6. If rear wheel was removed, install wheel (see Wheel
Installation in this section).
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may re-
sult in personal injury.
7. If rear wheel was removed, make sure that wheel lug
nuts are torqued from 75 to 85 ft- -lb (102 to 115 N- -m).
Chassis
8. Lubricate all grease fittings in rear steering assem-
bly.
9. Check and adjust wheel alignment (see Wheel Align-
ment in the Adjustments section of this chapter).
10.Check and adjust brakes (see Brake Adjustment in
the Adjustments section of this chapter).
11. After assembly and adjustments have been com-
pleted, make sure that no contact is made between any
machine components as the wheels are moved from
steering lock to lock. Adjust if necessary.
12.Position storage compartment to machine and se-
cure with removed fasteners (see Storage Compart-
ment Installation in this section or, if machine is
equipped with operator cab, in the Service and Repairs
section of Chapter 8 -- Operator Cab).
13.Close and latch hood.
Page 6 - - 32 Groundsmaster 360