Toro Groundsmaster 360 Service Manual page 279

Disassembly (Fig. 48)
1. Park machine on a level surface, lower cutting deck,
engage parking brake, stop engine and remove key
from the ignition switch.
2. Disconnect battery. Make sure to remove negative
battery cable first and then positive cable (see Battery
Service in this section).
3. Remove five (5) screws that secure control panel to
hydraulic tank cover (Fig. 49). Carefully lift and support
control panel to allow access to electrical connections.
4. Label all wire harness connectors for assembly pur-
poses.
5. Disconnect wire harness connectors from all electri-
cal components on control panel.
6. Remove knob from throttle control. Remove fasten-
ers that secure throttle control to control panel. Separate
throttle control from control panel.
7. Remove control panel from machine.
8. If necessary, remove hydraulic tank cover using Fig-
ure 48 as a guide.
Assembly (Fig. 48)
1. If hydraulic tank cover was removed, install cover us-
ing Figure 48 as a guide.
2. Position throttle control to control panel and secure
with removed fasteners. Install knob on throttle control.
3. Using labels placed during disassembly, connect
wire harness connectors to components on control pan-
el.
4. Place control panel on hydraulic tank cover and se-
cure with five (5) screws (Fig. 49).
5. Connect battery cables to battery. Make sure to con-
nect positive cable first and then negative cable (see
Battery Service in this section).
Groundsmaster 360
3
1. Screw (5 used)
2. Control panel
5
6
7
1. Ignition switch
2. 4WD diagnostic light
3. Throttle control lever
4. Hour meter
5. Oil pressure/alternator
Page 6 - - 45
1
1
Figure 49
3. Hydraulic tank cover
9
4
1
8
Figure 50
6. PTO switch
7. High temp/glow plugs
8. Lift/lower switch
9. 4WD steering switch
Chassis
2
3
2