Toro Groundsmaster 360 Service Manual page 185

Diagnostic Display
TEC Controller Inputs
ASSY
PRESENT
STEERING
OFF CTR
4 WHEEL
STEER
TEMP
WARNING
DECK
LIFT
DECK
LOWER
P BRAKE
OFF
SEAT
DIAG
MODE
TEMP
SHUTDOWN
ALT
FAULT
LOW OIL
PRESSURE
NEUTRAL
PTO
ENABLE
KEY START
(NOTE: Turn PTO switch ON so en-
gine will not start when turning ignition
switch to START)
KEY
RUN
NOTE: When the ignition switch is in the OFF position,
all Diagnostic Display LED's should be OFF.
NOTE: The TEMP WARNING and TEMP SHUTDOWN
inputs can be simulated by disconnecting the wire from
the warning or shutdown switch on the engine and then
grounding the wire. The appropriate input LED on the
Diagnostic Display should illuminate when the wire is
grounded and the ignition switch is in the RUN position.
Groundsmaster 360
Diagnostic Display
LED Operation
Optional kit with second TEC controller installed: LED ON
Optional kit with second TEC controller NOT installed: LED OFF
RH front wheel turned (not aimed straight ahead): LED ON
RH front wheel NOT turned (aimed straight ahead): LED OFF
Steering selector switch in 4 wheel steering position: LED ON
Steering selector switch in 2 wheel steering position: LED OFF
Engine coolant temperature has exceeded 220
Engine coolant temperature below 220
Deck lift switch pressed to lift (raise): LED ON
Deck lift switch NOT pressed to lift: LED OFF
Deck lift switch pressed to lower: LED ON
Deck lift switch NOT pressed to lower: LED OFF
Parking brake released: LED ON
Parking brake applied: LED OFF
Seat occupied: LED ON
Seat NOT occupied: LED OFF
Diagnostic mode shunt wires are connected: LED ON
Diagnostic mode shunt wires are not connected: LED OFF
Engine coolant temperature has exceeded 240
Engine coolant temperature below 240
Engine not running OR alternator faulty: LED ON
Alternator OK: LED OFF
Engine not running OR low engine oil pressure: LED ON
Engine oil pressure OK: LED OFF
Traction pedal in neutral: LED ON
Traction pedal in forward or reverse: LED OFF
PTO switch ON: LED ON
PTO switch OFF: LED OFF
Ignition switch in START: LED ON
Ignition switch in RUN: LED OFF
Ignition switch in RUN or START: LED ON
Page 5 - - 11
o o
F (105 C): LED ON
o o
F (105 C): LED OFF
o o
F (115 C): LED ON
o o
F (115 C): LED OFF
Electrical System