Toro Groundsmaster 360 Service Manual page 273

Installation (Fig. 39)
1. Position PTO drive shaft to machine. Make sure that
drive shaft slip shaft yoke (item 4 in Fig. 42) is toward
cutting deck gearbox shaft.
2. Align splines and roll pin holes of drive shaft yokes
with transmission and gearbox shafts.
3. Slide PTO drive shaft end yokes onto transmission
PTO shaft and gearbox shaft.
4. Secure end yokes of PTO drive shaft.
A. Install roll pins in end yokes and shafts.
B. Install cap screws in driveshaft end yokes. Alter-
nate direction that screw is installed on each yoke.
C. Install and tighten lock nuts to secure end yokes
to gearbox and PTO shafts. Torque lock nuts from
175 to 225 in- -lb (20 to 25 N- -m).
5. Lubricate PTO drive shaft grease fittings.
6. Connect the wire harness electrical connector to the
PTO solenoid valve coil connector (Fig. 40).
Groundsmaster 360
2
1. Transmission
2. Solenoid valve and coil
1. PTO drive shaft
2. Cap screw
3. Lock nut
1
2
4
1. End yoke
2. Cross and bearing set
3. Grease fitting
4. Slip yoke shaft
Page 6 - - 39
1
3
Figure 40
3. Coil connector
5
6
4
3
Figure 41
4. Roll pin
5. Transmission
6. PTO shaft
3
5
6
Figure 42
5. Grease fitting
6. Slip yoke tube
7. End yoke
1
2
2
7
Chassis