Air Conditioning Compressor - Toro Groundsmaster 360 Service Manual

Air Conditioning Compressor

RIGHT
FRONT
26 to 31 ft- -lb
(36 to 42 N- -m)
1. A/C compressor mount bracket
2. Flange nut (4 used)
3. Air conditioning compressor
4. Flange nut
5. Pulley
6. Cap screw (3 used)
Removal (Fig. 1)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Raise hood to allow access to engine.
3. Loosen flange nut that secures idler pulley. Move
pulley to loosen A/C compressor drive belt. Remove
drive belt from A/C compressor pulley.
Operator Cab
2
16
17
24 to 29 ft- -lbs
(33 to 39 N- -m)
Figure 1
7. Idler pulley
8. Carriage screw
9. Spacer
10. Cap screw (2 used)
11. Lock nut (2 used)
12. Screw (4 used)
4. Inspect compressor drive belt for glazing or damage.
Replace belt if necessary.
5. Disconnect compressor electrical connector from
machine wire harness.
6. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.
Page 8 - - 4
5
2
7
1
9
8
3
10
13. V- -belt
14. Reservoir bracket
15. Windshield washer reservoir
16. A/C hose (from evaporator)
17. A/C hose (to condenser)
6
13
15
14
12
4
11
Groundsmaster 360