Toro Groundsmaster 360 Service Manual page 301

5. Remove cutting blade, anti--scalp cup and blade bolt
from spindle to be serviced (Fig. 8).
6. Remove eight (8) flange head screws and flange
nuts that secure spindle assembly to deck. Remove
spindle assembly from deck.
Installation (Fig. 6)
1. Position spindle on cutting deck noting orientation of
grease fitting (Fig. 9). Secure spindle assembly to deck
with eight (8) flange head screws and flange nuts.
2. Install cutting blade, anti--scalp cup and blade bolt
(Fig. 8). Tighten blade bolt from 88 to 108 ft- -lb (119 to
146 N- -m).
3. Slowly rotate cutting blades to verify that blades do
not contact any deck component(s).
4. Install drive belt to pulleys.
5. Lubricate spindle grease fittings.
6. Install belt covers to cutting deck. Lower the footrest.
1
RIGHT
FRONT
1. RH spindle grease fitting
Groundsmaster 360
88 to 108 ft- -lb
(119 to 146 N- -m)
1. Flange screw (8 used)
2. Spindle assembly
3. Flange nut (8 used)
Figure 9
2. Center spindle grease fitting
Page 7 - - 11
2
6
Figure 8
4. Blade
5. Anti- -scalp cup
6. Blade bolt
3
2
3. LH spindle grease fitting
Cutting Deck
1
3
4
5