Rear Wheel Motors - Toro Groundsmaster 360 Service Manual

Rear Wheel Motors

RIGHT
FRONT
1. Rear wheel assembly (LH shown)
2. Hydraulic tube
3. Brake assembly (LH shown)
4. Hydraulic tube
5. Brake cable
6. Cap screw (2 per bracket)
7. Clevis pin
8. Brake cable bracket (LH shown)
9. Cap screw (2 per bracket)
10. Return spring bracket
Removal (Fig. 47)
WARNING
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section.
Hydraulic System
15
8
7
11
25
10
6
4
2
Loctite #271
11. Brake return spring
12. Wheel motor (LH shown)
13. Bulkhead nut (2 per bracket)
14. Cap screw (2 per bracket)
15. Rear axle
16. Square key
17. Brake support
18. Lock washer (4 per brake assy)
19. Cap screw (4 per brake assy)
Page 4 - - 64
5
27
9
26
13
14
12
16
17
26
21
3
22
94 to 116 ft- -lb
(128 to 157 N- -m)
Figure 47
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Loosen but do not remove lock nut (item 20) that se-
cures wheel hub to wheel motor. Also loosen wheel lug
nuts.
300 to 400 ft- -lb
(407 to 542 N- -m)
28
18
19
20
23
75 to 85 ft- -lb
(102 to 115 N- -m)
20. Lock nut
21. Cap screw (4 per wheel motor)
22. Wheel hub
23. Brake drum
24. Lug nut (5 per wheel)
25. Steering fork assembly
26. O- -ring
27. Hydraulic hose
28. Hydraulic hose
Groundsmaster 360
1
24