Toro Groundsmaster 4000-D Service Manual page 33

Removal (Fig. 11)
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch. Open and support hood.
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene- -glycol antifreeze is poisonous. Dis-
pose of coolant properly or store it in a properly
labeled container away from children and pets.
2. Drain radiator into a suitable container either by us-
ing the draincock (item 35) near the lower left side corner
of the radiator or by removing the lower radiator hose
from the radiator.
IMPORTANT: Follow all local codes and regulations
when recycling or disposing engine coolant.
3. Disconnect radiator hoses from the radiator.
Groundsmaster 4010--D machines with a Tier 4 compli-
ant engine (model 30607) use the lower radiator hose
assembly shown in Figure 12.
4. Remove air cleaner inlet hose (item 25).
5. Read the General Precautions for Removing and
Installing Hydraulic System Components in the Service
and Repairs section of Chapter 4 -- Hydraulic System.
6. Thoroughly clean hydraulic lines at lower radiator
shroud (Fig. 13) and oil cooler ports (Fig. 14). Discon-
nect hydraulic lines and put caps or plugs on lines to pre-
vent contamination. Label disconnected hydraulic lines
for proper installation.
7. Disconnect hood rods from hood and radiator sup-
ports (see Hood in the Service and Repairs section of
Chapter 7 -- Chassis).
8. Remove flange head screws (item 8) and flange nuts
(item 6) that secure the radiator supports (items 1 and
28) to the frame.
9. Carefully raise radiator assembly with shrouds, fan
motor assembly and supports from the machine.
10.Disassemble radiator/oil cooler assembly as needed
using Figures 11 and 13 as guides.
11. If necessary, remove hydraulic fittings (items 29 and
31) from oil cooler and discard O--rings.
12.Plug all radiator and hose openings to prevent con-
tamination.
Groundsmaster 4000--D/4010--D
MODEL 30607 (WITH TIER 4 ENGINE)
RIGHT
FRONT
2
1. Radiator/oil cooler
2. Lower radiator hose
3. Hose clamp
RIGHT
FRONT
4
5
1. Radiator/oil cooler
2. Motor and fan assembly
3. Cap screw (6 used)
Page 3 - - 15
1
5
6
3
4
3
Figure 12
4. Radiator fitting
5. Hose clamp
6. Radiator hose
3
1
2
Figure 13
4. Flange nut (6 used)
5. Lower radiator shroud
Yanmar Diesel Engine