Running The Slot To Slot Test (Support > Run Slot To Slot Test); Running The Wellness Test (Support > Run Wellness Test) - HP StoreEver MSL2024 User And Service Manual
Hide thumbs
Also See for StoreEver MSL2024:
- Quickspecs (26 pages) ,
- Quickspecs (25 pages) ,
- Quickspecs (30 pages)
Table of Contents
Advertisement
NOTE:
To stop the demonstration, press Cancel on the OCP.
Running the slot to slot test (Support > Run Slot To Slot Test)
Use this option to show the robot's ability to move media in and out of each of the magazine
slots. Access to this feature requires the administrator password.
NOTE:
At the end of the test, the cartridges are NOT returned to their original slots.
To run the slot to slot test:
1.
From the Home screen, press Previous or Next until the screen displays Support. Press
Enter to select.
2.
Press Previous or Next until the screen displays Run Slot To Slot Test. Press Enter to
select.
3.
Enter the administrator password, if prompted.
4.
Press Previous or Next until the screen displays Select Number of Cycles. Use Previous
or Next to select the number of cycles: 270, 540, 1080, or Endless. Press Enter.
5.
While the test is running, the screen displays progress as shown: Run Slot To Slot. The
second line on the display shows the number of cycles completed. The Ready LED blinks
until the test is complete.
6.
When the test is complete, the screen displays the number of cycles completed and the
number of errors. If the test failed, press Enter to display the error and message describing
the cause.
NOTE:
To stop the slot to slot test, press the Cancel button.
Running the wellness test (Support > Run Wellness Test)
Use this option to check the health of the device for the specified number of loops. If a failure
occurs during the test, check the error code and failure message for more information. Access
to this feature requires the administrator password. For more information about the wellness test,
see
"The wellness test" (page
For complete testing, enable the mailslot and ensure that each top-row corner slot contains a
tape cartridge. During the test, the device will open the mailslot and ask you to insert a tape
cartridge. You can use any compatible Ultrium data tape cartridge for this test.
IMPORTANT:
running the wellness test. Verify that any applications using the device have completed before
starting the wellness test.
To run the wellness test:
1.
From the Home screen, press Previous or Next until the screen displays Support. Press
Enter to select.
2.
Press Previous or Next until the screen displays Run Wellness Test. Press Enter to select.
3.
Enter the administrator password, if prompted.
4.
On a library with two tape drives, press Previous or Next to select the tape drive to test:
Drive 1, Drive 2, or All Drives. Press Enter to select the drive option.
5.
Use Previous or Next to select a number of cycles: 1 - 10. Press Enter.
6.
While the test is running, the screen displays progress as shown: Wellness test. The second
line on the display shows the number of cycles completed. The Ready LED blinks until the
test is complete.
7.
When the test is complete, the screen displays the test completion status, including any
recoveries or errors that might have occurred. See
codes and error messages.
108 Operating the tape library
146).
The device will remove any tape cartridges from tape drives and go offline when
Error codes (page 149)
for a list of error
Advertisement
Table of Contents
