Panasonic Eco Solutions Nordic AB
MEW01603 Rev: -
5.2
Escape
menu
Output (B2)
Up to 200 outputs can be individually disabled via menu B2.
Cont. from
, page 7.
B1 Zone or Zone / Address
Press ( ).
B2 Output
Press ( ).
Disable output
NOTE! To Re-enable, see ➓ below.
By default is Loop unit 000000 output 0 selected. Press the Soft
key "Change type of disablement" to toggle between:
Loop unit 000000 output 0
Control unit 00 S0
Control unit 00 R0
Control unit 00 expansion board output 0.
Use the keypad to type the required data. Press ( ).
A successful disablement is indicated by a beep and a
shown in the Re-enable list.
A not successful disablement is indicated by another beep and a
Re-enable
➓ Press the Soft key
Disable output
Re-enable list.
Press ( ) to highlight the output that shall be Re-enabled.
⓫ Press ( ). A successful Re-enablement is indicated by a beep and it
will also disappear from the Re-enable list
⓬ To leave a menu press ESC.
To leave the menu system press the Soft key "Escape menu".
EBL512 G3 version 2.0.x, Daily user's manual
⇥
to toggle between:
"
"
9
It will also be
"√".
"X".
.