NEC DS1000 Quick Setup Manual page 17

(DS1000)
For Analog Voice Mail (such as analog VANGARD and NVM-2e)
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
9902:STATION CARDS
D-DGTL/A-ANLG/X-DBOX
3. Enter
9902:ANALOG PORTS
PORT:17 STATION:17
4. Press
is connected.
5. Enter
9902:SLOT:n:nASTU
PORT:17 STATION:201
6. Press
installed Voice Mail ports.
7. Press
Press
For Digital VANGARD
Each Digital VANGARD connection is a two-channel device that represents two Voice Mail ports (stations).
In programming, you assign a separate Voice Mail station (201-208) to each channel. The first channel is
called the primary station; the second channel is called the secondary station.
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
9902:STATION CARDS
D-DGTL/A-ANLG/X-DBOX
3. Press
9902:STATION CARDS
PORT:01 PRI STA?1
4. Press
GARD is connected.
5. Enter
9902:STATION CARDS
STATION ASSIGNED
6. Press
9902:STATION CARDS
PORT:nn SEC STA?UND
7. Enter
9902:SLOT:n:16DSTU
PORT:nn SEC STA?202
8. Repeat steps 4-8 to assign Voice Mail stations to the remaining installed Digital VANGARD Voice
Mail ports.
9. Press
Press
DS1000/2000 Quick Setup Guide
+ . You see:
9902 HOLD
A (2). You see:
VOL Up until you select the first (lowest numbered) analog port to which your analog Voice Mail
201 + HOLD twice. You see:
VOL Up , then repeat step 5 to assign additional Voice Mail stations (202-208) to the remaining
to go back to step 3.
CONF
OR
CONF twice to exit program 9902.
9902 + HOLD . You see:
D (3). You see:
VOL Up until you select the first (lowest numbered) digital port to which your Digital VAN-
201 + HOLD . You see:
again + . You see:
HOLD VOL Up
202 + HOLD twice. You see:
CONF to go back to step 3.
OR
CONF twice to exit program 9902.
Section 1: Start-up Programming
Section 1: Start-up Programming ◆ 1-13
1