NEC DS1000 Quick Setup Manual page 41

6. Press
Press
Part III: Program Analog Door Box Relay Control
To set up the relays for Door Box strike control:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
0201:TENANT OPTIONS
CALL WAIT?nnn
3. Press
0201:TENANT OPTIONS
DOOR1 RELAY?nnnn
4. To have the analog Door Box plugged into DOOR1 activate its associated relay, dial
Up . You see:
0201:TENANT OPTIONS
DOOR2 RELAY?nnnn
5. To have the analog Door Box plugged into DOOR2 activate its associated relay, dial
Up . You see:
0201:TENANT OPTIONS
PAGE ZONE?nnnn
6. Press
To activate the relay for each Door Box:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1801:EXTENSION PROG
EXTENSION #?nnn
3. Enter the extension number of the Door Box you want to program +
1801:EXT:nnn
PT TYP?10:DOOR BOX
4. Press
1801:EXT:nnn
RELAY OWNER?nnnn
5. If the analog Door Box you are programming is connected to DOOR1, dial
If the analog Door Box you are programming is connected to DOOR2, dial
6. Press
Press
Feature Quick Steps
To place a call to the Door Box:
●
To answer the Door Box chimes from a keyset:
●
To control the system relay which in turn controls the door strike.
●
DS1000/2000 Quick Setup Guide
CONF to return to step 3 and add an extension to the Door Box Ring Group.
OR
CONF twice to exit program 1802.
+ . You see:
0201 HOLD
VOL Up until you see:
CONF to exit program 0201.
1801 + HOLD . You see:
VOL Up until you see:
OR
CONF to go back to step 3 and select another Door Box.
OR
twice to exit program 1801.
CONF
Lift handset and press ICM
Lift handset or press SPK
To open the relay, press FLASH
To close the relay, press
Section 2: Customizing Features
+ Dial the Door Box extension number.
.
key or OPEN soft key.
FLASH key or CLOSE soft key.
Section 2: Customizing Features ◆ 2-17
1 + HOLD +
1 + HOLD +
. You see:
HOLD
1 + HOLD .
+ .
2 HOLD
VOL
2
VOL