How To Exit The Programming Mode; Using Keys To Move Around In The Programs - NEC DS1000 Quick Setup Manual

Section 1: Start-up Programming

How to Exit the Programming Mode

To exit the programming mode:
1. When you see:
USER: nnn
ENTER PROGRAM?
DS1000 VER nn.nn.nn
PASSWORD:
Press and release the hookswitch, or press SPK .

Using Keys to Move Around in the Programs

Once you enter the programming mode, use the keys in the following chart to enter data, edit data and move
around in the menus.
1-6 ◆ Section 1: Start-up Programming
OR
If you don't see one of the above prompts, press CONF until you do. When you exit program-
ming, the system automatically stores your entries in Random Access Memory (RAM).
Use this key:
0-9, # and *
HOLD
CONF
LND
CLEAR
CHECK
VOL Up
VOL Down
ICM
When you want to:
Enter data into the program.
Complete the programming step you just made (like pressing Enter
on a PC keyboard). When a program entry displays, press HOLD to
accept the entry (i.e., bypass the entry without changing it).
Complete the programming step you just made (like pressing
on a PC keyboard) and back up one step in the program.
Enter
Delete the entry to the left (like pressing Backspace on a PC key-
board). To delete an entire name entry (without backspacing over
each letter), just reenter the name without pressing LND first.
Erase the entire command line you just entered and undefine the
entry.
Erase the entry you just made and replace it with the prior stored
entry.
Scroll forward through a list of entries in a program. If you enter
data and then press this key, the system accepts the data before
scrolling forward to the next entry.
Scroll backward through a list of entries in a program. If you
enter data and then press this key, the system accepts the data
before scrolling backward to the previous entry.
Enable the scroll mode. When you press this key and it lights,
you can then press VOL Up and VOL Down to scroll through the
options. To choose the displayed value, press HOLD .
DS1000/2000 Quick Setup Guide