Technical Specifications - Motorola PL3307 Integration Manual

Technical Specifications

Table 2-5 provides the technical specifications for the PL3307 decoder. Note that current draw figures are valid
for a PL3307 with an attached SE3300WA imager engine.
PL3307 Decoder Technical Specifications at 23°C
Table 2-5
Power Requirements:
Host Supply 3.3 V (HOST_3P3):
Supply Voltage
Low Power Current
Idle Current
Operating Current
Peak Current
Host Supply 5.0 V (USB2_5V or HOST_5V):
Supply Voltage
Suspend Current Draw
Idle Current
Operating Current
Peak Current
Maximum Power Supply Noise
Start Up Time
From Power On
From Low Power Mode
Baud Rate
Temperature
Operating
Storage
Humidity
Operating
Storage
Shock
Item
Installation and Specifications 2 - 13
Description
Supply currents listed below are typical values in mA, RMS, at
nominal supply voltage unless otherwise specified.
3.3 V +/- 0.3 V
15 mA
45 mA
280 mA (scan/decode session)
400 mA (see Figure 2-3 on page
Applies only when PL3307 is USB bus powered via the micro
USB port
5.0 V +/- 0.5 V
15 mA
35 mA
270 mA
400 mA
See Figure 2-5 on page 2-8
100 mVp-p - bar code and image capture applications,
host supply = 5 VDC (HOST_5V or USB2_5V)
100 mVp-p - bar code applications,
host supply = 3.3 VDC (HOST_3P3 only)
30 mVp-p - image capture applications,
host supply VCC = 3.3 VDC (HOST_3P3 only)
RS-232: 1200 ms typical (RS-232)
USB: Host dependent
3 ms typical
9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600
-30° C to 55° C (-22° F to 131° F)
-40° C to 70° C (-40° F to 158° F)
95% RH, non-condensing at 55°C
85% RH, non-condensing at 70°C
2000 G ± 5% applied via any mounting surface at -30º C
and 55º C for a period of 0.85 ± 0.05% msec
2500 G ± 5% applied via any mounting surface at 20º C for a
period of 0.85 ± 0.05% msec
2-6)