Prefix/Suffix Values - Motorola PL3307 Integration Manual

4 - 28 PL3307 Decoder Integration Guide

Prefix/Suffix Values

Key Category Parameter # P = 63h, S1 = 62h, S2 = 64h
Decimal Value Parameter # P = 69h, S1 = 68h, S2 = 6Ah
You can append a prefix and/or one or two suffixes to scan data for use in data editing. To set a value for a
prefix or suffix, scan the prefix or suffix bar code below, then scan a four-digit number (i.e., four bar codes from
Appendix D, Numeric Bar
of character to send) and is stored in the key category parameter. The remaining three digits define the value
of the character and are stored in the decimal value parameter. Be sure to use both key category and decimal
value parameters to define the prefix/suffix value. See
When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the 3-digit
decimal value. See
To correct an error or change a selection, scan
NOTE To use Prefix/Suffix values, set the
Scan Prefix
Scan Suffix 2
Codes) that corresponds to that value. The first digit defines the key category (type
Table E-1 on page E-1 for the four-digit codes.
(07h)
(08h)
Table E-1 on page E-1
Cancel on page D-2.
Scan Data Transmission Format on page 4-29
for the four-digit codes.
.
Scan Suffix 1
(06h)