Timeout Between Decodes, Same Symbol; Timeout Between Decodes, Different Symbols - Motorola PL3307 Integration Manual

4 - 20 PL3307 Decoder Integration Guide

Timeout Between Decodes, Same Symbol

Parameter # 89h
Use this option in Presentation Mode to prevent multiple reads of a symbol left in the decoder's field of view.
The timeout begins when you remove the symbol from the field of view.
To select the timeout between decodes for the same symbol, available in 0.1 second increments from 0.0 to
9.9 seconds, scan the bar code below, then scan two numeric bar codes from
that correspond to the desired interval. The default interval is 0.6 seconds.
NOTE The Timeout Between Decodes, Same Symbol value must be greater than the
Decodes, Different Symbols

Timeout Between Decodes, Different Symbols

Parameter # 90h
Use this option in Presentation Mode or Continuous Bar Code Read to control the time the decoder is
inactive between decoding different symbols. It is programmable in 0.1 second increments from 0.1 to 9.9
seconds. The default is 0.2 seconds.
To select the timeout between decodes for different symbols, scan the bar code below, then scan two numeric
bar codes from Appendix D, Numeric Bar Codes
increments.
NOTE The Timeout Between Decodes, Different Symbols value cannot be greater than or equal to the
Timeout Between Decodes, Same Symbol
Timeout Between Decodes, Different Symbols
value.
Timeout Between Decodes, Same Symbol
that correspond to the desired interval, in 0.1 second
or the Decode Session Timeout on page 4-19
Appendix D, Numeric Bar Codes
Timeout Between
value.