Scanning Sequence Examples; Errors While Scanning; Imaging Preferences Parameter Defaults - Motorola PL3307 Integration Manual

5 - 2 PL3307 Decoder Integration Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable image capture
illumination, scan the Disable Image Capture Illumination bar code under
page 5-10. The decoder issues a fast warble beep and the LED turns green, signifying a successful parameter
entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Imaging Preferences Parameter Defaults

Table 5-1 lists the defaults for imaging preferences parameters. To change the default values, scan the
appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall
the default parameter values, scan the
NOTE See
miscellaneous default parameters.
Imager Preferences Default Table
Table 5-1
Imaging Options
Decoding Autoexposure
Decoding Illumination
Decode Aiming Pattern
Aim Brightness
Illumination Brightness
Presentation Mode Field of View
Frame Rate
Image Capture Autoexposure
Image Capture Illumination
Fixed Gain
Exposure Time
LED Illumination
Snapshot Mode Timeout
Set Default Parameter on page
Appendix A, Standard Default Parameters
Parameter
4-5.
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
F0h 29h Enable
F0h 2Ah Enable
F0h 32h Enable
F0h 9Ch 0
F0h 9Dh 10
F1h 61h Default (Reduced)
F1h A2h Auto
F0h 68h Enable
F0h 69h Enable
F1h 38h 50
F4h F1h 37h 100 (10 ms)
F0h ADh Internal LED Illumination
F0h 43h 0 (30 seconds)
Image Capture Illumination on
Page
Number
5-5
5-5
5-6
5-6
5-7
5-7
5-8
5-10
5-10
5-11
5-11
5-12
5-14