Sharp AR-FX12 Service Manual page 35

66-36
Purpose Operation test, check
Function (Content) Used to check I/F between MFPC and MDMC.
Check is made in the data line or the command
line.
Section FAX
Item Operation
Operation/Procedure 1) Select with 10 digit key pad and press START.
2) When check is "repeat,"
executed until the result becomes NG or
CUSTOM SETTING is pressed.
SIMULATION 66-36
MFPC-MDMC I/F CHECK . INPUT 1-8, AND PRESS START.
1. MFPC<-MDMC(DATA once)
2. MFPC->MDMC(DATA once)
3. MFPC<-MDMC(DATA repeat)
4. MFPC->MDMC(DATA repeat)
5. MFPC<-MDMC(CMD once)
6. MFPC->MDMC(CMD once)
7. MFPC<-MDMC(CMD repeat)
8. MFPC->MDMC(CMD repeat)
Press [START] key.
SIMULATION 66-36
MFPC-MDMC I/F CHECK . INPUT 1-8, AND PRESS START.
EXECUTING...
When check is "once" or "repeat"
and the result is NG
SIMULATION 66-36
MFPC-MDMC I/F CHECK . INPUT 1-8, AND PRESS START.
EXECUTING...(OK or NG)
<List of display values>
1 MFPC <- MDMC
2 MFPC -> MDMC
3 MFPC <- MDMC
4 MFPC -> MDMC
5 MFPC <- MDMC
6 MFPC -> MDMC
7 MFPC <- MDMC
8 MFPC -> MDMC
the operation is
1
1
When check is "repeat" and
[CUSTOM SETTINGS] key is pressed.
Data line once only
Data line once only
Data line repeat
Data line repeat
Command line once only
Command line once only
Command line repeat
Command line repeat
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-23
66-39
Purpose
Function (Content) Registration of FAX destination
Section FAX
Item
Operation/Procedure The current destination saved in the EEPROM of
FAXBOX is displayed.
Entries of 1 - 6 only are valid. Enter the number
corresponding to your desired destination.
(If no destination is saved in the EERPOM of
FAXBOX, "0" is displayed.)
1) Enter the number with the 10-key and press
[START] key, and the destination will be
written on the FAX.
SIMULATION 66-39
FAX DESTINATION SETUP.
SELECT 1 - 6, AND PRESS START
0. NO DESTINATION
1. JAPAN
2. U.S.A/CANADA
3. EUROPE
4. AUSTRALIA
5. CHINA
6. ASIA
press [START] key
<List of display values>
1 Japan
2 North America
3 Europe (including U.K.)
4 Australia
5 China
6 Asia
1