Sharp AR-FX12 Service Manual page 48

SW Bit Item
No. No.
31 1-4 ID (No.) setting 2
(2nd digit: When dial
inputting or dialing)
5-8 ID (No.) setting 3
(3rd digit: When dial
inputting or dialing)
32 1-8 Not used
33 1,2 Transmission cable
amplitude equalizer
3-7 Not used
8 Paper selection when
reception printing
(LTR/A4)
34 1-7 Not used
8 Duplex reception print
35 1 Rotational print
2 Sub scan length
judgment
3,4 Received data print
condition setup
Switch selection and function
Used to set the ID No. when the PBX function is enabled. This setting is valid
when "ID" is set in SW59-7-8.If the set value is outside the specified range, it is
not used as an ID No.
Used to set the ID No. when the PBX function is enabled. This setting is valid
when "ID" is set in SW59-7-8.If the set value is outside the specified range, it is
not used as an ID No.
Used to set whether the send level is changed by frequency or not when
sending FAX signal.
Bit No.
0dB
4dB
8dB
12dB
Used to set whether LTR is confirmed first of all in selection of paper for
reception printing or paper that provides smaller reduction rate of A4 and LTR is
selected.
1: Priority on LTR 0: Priority on LTR/A4 reduction rate
Used to set whether reception data are printed on duplex surfaces when
printing FAX reception.
1: Duplex reception is
printed.
Used to set whether rotation print is made or not when received data can be
printed by rotating in FAX reception printing.
1: Received data are not
rotated.
Used to set whether priority is given to the width or the length when selecting
the optimum paper in received data printing.
1: Priority on data width
Used to set selection of the optimum paper for received data printing.
Bit No.
Optimum size/Large size/reduction
Optimum size/Large size
Optimum size/Large size/Division
Optimum size/Large size/reduction
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-36
1 2
0 0
0 1
1 0
1 1
0: Duplex reception is not
printed.
0: Received data are
rotated.
0: Priority on data length
3 4
0 0
0 1
1 0
1 1
USA Initial value Key
operator
0 Not used Initial set up
0
0
0
0 Not used Initial set up
0
0
0
0
0
0
0
0
0
0
0
0 0dB
0
0
0
0
0
0
0 Priority on
LTR/A4
0
0
0
0
0
0
0
0 Not print Receive
setup
0 Rotational
print
0 Priority on
data length
0 00 Receive
setup
0