Sharp AR-FX12 Service Manual page 12

<4>Select the desired destination from the destination list (separate
table 1) by entering the number using the 10-key pad and press the
[START] key.
(For example, to set the UK as the destination, enter [10110100]
using the 10-key pad and then press the [START] key.
<5>Check the destination in the following screen. If the destination is
correct, enter [1] (YES) using the 10-key pad and press the [START]
key.
<6>Press the [CA] key.
* This machine will be rebooted and will start with the setting of the
selected destination for the fax.
Separate table 1: Setting value of destination for fax
Destination
U.S.A 1 0
AUSTRALIA 0 0
NEWZEALAND 0 1
U.K. 1 0
FRANCE 0 0
GERMANY 0 0
SWEDEN 1 0
13)Clear the image memory.
• If an additional memory (AR-MM9) has been mounted, be sure to carry
out this step.
If no additional memory has been mounted, this step is not necessary.
<1>Switch the operation panel to the copy mode and use the key
operation [P], [*], [C], and [*] to enter the simulation mode.
<2>Use the 10-key pad to enter [66] in the main code entry screen and
press the [START] key.
<3>Use the 10-key pad to enter [10] in the sub-code entry screen and
press the [START] key.
FAX Software SW No.1 - 8
1 1 0 1 0
0 0 1 0 0
1 1 1 1 1
1 1 0 1 0
1 1 1 1 0
0 0 0 1 0
1 0 0 1 0
AR-FX12 UNPACKING AND INSTALLATION 5-3
<4>Use the 10-key pad to enter [1] in the submenu screen and press the
[START] key.
<5>The screen shown below is displayed and memory clear operation is
executed.
<6>After several minutes, memory clear operation will be completed and
then this machine will be automatically rebooted.
14)Connect the line cable to the fax box unit.
Connect the line cable to the fax box unit.
As shown in the figure, insert the FAX cable terminal (with the core
attached) into the FAX box unit.
1
1
0
0
1
0
1