Toshiba IPEDGE User Manual page 55

Hold a Conference
Call
Consultation Hold (SIP
only)
Adding Voice Mail to a
Conference
Add Voice Mail to a
Conference Call
(conference master
only)
Supervising a Tandem
Call
IPedge UG 12/15
3. While talking to one party, press the Conf key to join the calls.
Only the conference master may place a conference call on hold by pressing
Hold once (or twice for Executive Hold). The other parties may continue with the
conference. Music-on-Hold is disabled and the line extension LED flashes green.
Rejoin the conference at any time by pressing the extension button. Conference
master status is retained through this process.
This feature allows you to place a call on hold then dial another station or outgoing
line to consult.
1. While on a call press the Conf soft key. The held party will hear system music
on hold.
2. Dial a station or make an outgoing call.
3. Press the Swap soft key to alternate between the two parties.
While talking to any party, press the End key to disconnect the call.
The conference master may add voice mail to a conference. This feature enables
participants in a conference to listen to or leave a voice mail message during a
conference call.
1. Press Cnf/Trn to place the current call on Consultation Hold.
2. Dial the voice mail (VM) extension number, then enter the VM mailbox and
security code. This adds the voice mailbox to the conference.
3. Press Cnf/Trn to reconnect to the original party. (You may continue to add
conference members by pressing Cnf/Trn and dialing another extension.)
Now, all parties in the conference may listen to or record a message to
this voice mailbox. Only the Master may control the VM with Soft Keys.
1. While on an outside call, press Cnf/Trn. A dial tone is heard and the
extension LED flashes (conference rate.)
2. Dial an outside telephone number.
3. After party answers, press Cnf/Trn. Extension LED flashes (in-use rate) and
all parties are conferenced.
4. If busy/no answer, press the flashing extension button to return to the original
connection.
5. Press Cnf/Trn and hang up. The extension LED flashes (exclusive-hold rate)
and the two lines are connected. The LED turns off when the parties hang-up.
6. To supervise a tandem call, press the extension button. If the parties have
finished, hang up. If the parties are still talking, press Cnf/Trn and hang-up.
Both Line LEDs turn off and the connection is released.
If your telephone service provider offers automatic disconnect
Note:
supervision, the connection will release automatically when the parties
hang up. If not, the lines must be supervised and manually disconnected.
TOSHIBA
IPedge
Feature Operations
51