Toro 41177 Multi-Pro 1250 Operator's Manual page 19

Figure 13
1. Parking brake lever
Speed Limiter
The speed limiter is a large knob located to the
right of the seat (Figure 14). It allows you to set
the maximum downward travel of the accelerator
pedal, thereby limiting the maximum rpm of the
engine. This indirectly limits the speed of the
sprayer.
Note: The vehicle controls the application rate
based on your speed and you do not need to keep
a constant speed to apply at a constant rate.
Figure 14
1. Speed limiter knob
2. Speed limiter button
Choke Control
The choke control is a small knob to the right
of the seat. (Figure 14). To start a cold engine,
pull the choke control up. After the engine starts,
regulate the choke to keep the engine running
3. Locking ring
4. Choke control
smoothly. As soon as possible, push the control
down to the Off position. A warm engine requires
little or no choking.
Range Selector
The range selector, located to the left of the seat,
has 5 positions: 3 forward speeds, Neutral, and
Reverse (Figure 15). The engine will start only
when the range selector is in the Neutral position.
You must also fully press the brake with the
sprayer stopped to change ranges.
Important: Do not shift out of or change
ranges while the vehicle is moving. Attempting
to change ranges while the vehicle is moving
can damage the transmission. Only stopping
the sprayer completely, and fully engaging the
brake will safely disengage the locking pin
and allow the ranges to be changed.
Figure 15
1. Range Selector
2. Ignition switch
3. Hour meter
Ignition Switch
The ignition switch (Figure 15), used to start
and stop the engine, has 3 positions: Stop, Run,
and Start. Rotate the key clockwise to the Start
position to start the engine and release it to the
Run position when started. Rotate the key to the
Stop position to stop the engine.
19
4. Voltmeter
5. Headlight switch
6. Neutral engine speed lock
switch