Operating The Booms - Toro 41177 Multi-Pro 1250 Operator's Manual

Important: Verify that the proper
application rate has been set prior to filling the
tank with chemicals.
1. Stop the sprayer on a level surface, move the
range selector to the Neutral position, stop the
engine, and set the parking brake.
2. Ensure that the tank drain valve is closed.
3. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
4. Open the tank cover on the spray tank.
The tank cover is located in the center of the
top of the tank (Figure 25). To open it, turn
the front half of the cover counterclockwise
and swing it open. You can remove the strainer
inside for cleaning. To seal the tank, close the
cover and rotate the front half clockwise.
1
Figure 25
1. Tank cover
5. Add 3/4 of the required water to the spray
tank using the anti-siphon fill receptacle.
Important: Always use fresh clean water
in the spray tank. Do not pour concentrate
into an empty tank.
6. Start the engine, press the accelerator pedal to
the floor, and set the neutral engine speed lock
to the On position.
7. Set the pump switch to the On position.
8. Set the master boom switch to the Off position.
The Spray Pro monitor will display "HOLD".
2
G001897
2. Anti-siphon ll receptacle
9. Turn the agitation control valve to the 9 o'clock
position to start agitation in the tank.
10. Add the proper amount of chemical
concentrate to the tank, as directed by the
chemical manufacturer.
Important: If you are using a wettable
powder, mix the powder with a small
amount of water to form a slurry before
adding it to the tank
11. Add the remaining water to the tank.

Operating the Booms

The boom lift switches on the sprayer control
panel allows you to move the booms between
transport position and spray position without
leaving the Operator's seat. It is recommended
to change boom positions while the machine is
stationary.
To change the boom position:
1. Stop the sprayer on level ground.
2. Use the boom lift switches to lower booms.
Wait until the booms reach the full, extended
spray position.
3. When the booms need to be retracted, stop the
sprayer on level ground.
4. Use the boom lift switches to raise the booms.
Raise the booms until they have moved
completely into boom transport cradle forming
the "X" transport position and the boom
cylinders are fully retracted.
Important: To prevent damage to
the boom actuator cylinder, make sure
the actuators are fully retracted before
transport.
The Boom Transport Cradle
The sprayer is equipped with a boom transport
cradle that has a unique safety feature. In the event
of accidental boom contact with a low overhead
object while in the transport position, the boom(s)
can be pushed out of the transport cradles. If
this occurs, the booms will come to rest in a near
horizontal position to the rear of the vehicle.
While the booms will not be damaged due to this
29