Toro 41177 Multi-Pro 1250 Operator's Manual page 23

Spray Pro™ Monitor
The Spray Pro monitor displays and monitors
various system performance data such as vehicle
speed and application rates. It does not control
the application rate.
1. LCD screen
2. Selection dial
3. Total area
4. Speed
5. Units of measure
Monitor Display Selection Dial
Use the dial to set the LCD screen display to the
following:
• Total area
Displays the total acres (US), hectares (SI), or
sq feet (TURF) that you have covered since
you last pressed the Reset calibration button
for this setting.
• Speed
Displays the ground speed in miles per hour (if
the Units of Measure is set to US or TURF) or
kilometers per hour (if the Units of Measure
is set to SI).
• Units of Measure
Displays the current measurement unit
selection as follows:
– US (United States measuring system)
Figure 20
6. Application rate
7. Distance
8. Sub Area
9. Sub volume
10. Total volume
The monitor has an LCD screen that displays the
data you select, a selection dial, and 4 buttons for
calibrating the monitor (Figure 20).
11. Reset, calibration button
12. Calibrate, calibration button 17. Width
13. Decrease, calibration button 18. Speed calibration
14. Increase, calibration button 19. Flowmeter calibration
15. Boom selection
– SI (metric system)
– TURF (as US but the volumes are in US
gallons per 1000 sq ft instead of US gallons
per acre)
• Application Rate
Displays the application rate in US gallons per
acre (US), liters pre hectare (SI), or US gallons
per 1000 sq ft (TURF).
• Sub Area
Displays the total acres (US), hectares (SI), or
sq feet (TURF) that you have covered since
you last pressed the Reset calibration button
for this setting, without affecting the Total
Area display. If you press the Reset calibration
button, the Sub Volume resets.
• Distance
23
16. Select units
20. LED