Cleaning The Cab Air Filters; Cleaning The Air-Conditioning Assembly - Toro 31598 Operator's Manual

Cleaning the Cab Air Filters

Service Interval: Every 250 hours
1. Remove the screws and grates from both the in-cab
and rear cab air filters
1
Figure 102
In-Cab Air Filter
1. Filter
2. Grate
Figure 103
Rear Cab Air Filter
1. Filter
2. Grate
2. Clean the filters by blowing clean, oil-free, compressed
air through them.
Important: If either filter has a hole, tear, or other
damage, replace the filter.
(Figure 102 and Figure
3
3. Screw
1
2
3
3. Screw
3. Install the filters and the grate with the thumb screws.
Cleaning the Air-Conditioning
Assembly
103).
Service Interval: Every 250 hours (more frequently in
2
1. Perform the premaintenance procedure; refer to
Preparing the Machine for Maintenance (page
2. Disconnect the wire for each fan.
g028378
1. Fan
2. Wire
3. Remove the 2 knobs and remove the fan assembly.
4. Open the 4 latches on the air-conditioning assembly
and remove the screen.
2
1. Air-conditioning coil
g028379
2. Latch
5. Remove the air filters (see
6. Clean the air-conditioning assembly.
7. Install the air filters, screen, and fan assembly
103, Figure
8. Connect the wire for each fan
63
extremely dusty or dirty conditions).
Figure 104
Right fan shown
3. Knob
Figure 105
3. Air-conditioning screen
Figure 103).
105, and Figure 104).
(Figure
38).
(Figure
104).